Megger KC1-C Heavy duty clip for general purpose applications. Duplex connect test lead system for use with any Megger 10 A DLRO and BT51 instruments Heavy Duty Kelvin Clip-Connect (X1) The Megger DLRO duplex connect four terminal test lead system is designed to provide the most cost effective and convenient way to provide the user with all of the test lead terminations and lead lengths required for the many different applications encountered in low resistance testing.At the center of this unique test lead system is a bespoke connector allowing terminations such as kelvin clips or duplex test probes to be changed as required. There are two connector versions, one being fitted with indicator LEDs that operate with the DLRO10 range of instruments. The indicator LEDs provide enhanced safety and convenience with indications as follows: DLRO10, DLRO10X, DLRO10HD and DLRO10HDX Warning of connection to hazardous live voltage (Not DLRO10X, warning is given on the display)When continuity is madeWhen a test complete and measurement is on instrument displayDLRO10X addsIndication of pass / fail to user set test limitsAll of these important indications are therefore seen near the point of connection without needing to view the instrument display. There is even a 6 m extension lead to provide the ultimate in flexibility.SAFETY WARNINGSThese safety warnings must be read and understood before the instrument is used.Always refer to the user manual of the instrument being used with these test leads.Do not touch the universal connector during test or while connected to hazardous voltages.Whenever possible, circuits should be de-energized before testing.If it is impossible to de-energize the circuit, (e.g. high voltage batteries cannot be switched off while their connections are tested) the user must be aware of the dangers. The instrument terminals will become live when connected to the circuit.